Coolant Level - Check; Air Cleaner - Check For Clogging; Air Tank - Drain Water; Fig. 3-15 Air Cleaner - Check For Clogging - Mitsubishi S16R Operating Instructions Manual

Chapter 3 OPERATION

Coolant Level - Check

Always use the coolant having the same concentration.
If the coolant level is low, add coolant to the specified level.
Note: Determine the quantities of LLC based on the coolant capacity and the LLC concentration chart.
For the coolant, refer to

Air Cleaner - Check for Clogging

1. Check the air cleaner indicator for the element
clogging.
2. If the element is clogged, the red signal mark will
be displayed.
3. Immediately clean or replace the air cleaner ele-
ment when the signal turns red.
4. After checking, press the bottom on top of the indi-
cator to re-set the alarm signal.
Note: (a) For cleaning of the air cleaner element, refer
to "Air Cleaner Element - Clea n, Check and
Replace" (8-21).
(b) If the specification of air cleaner differs from
the contents of this operation manual, follow
the manufacturer's operation manual.

Air Tank - Drain Water

There are 2 places for draining water in the air tank:
drain valve on the top of air tank, and drain handle
on the bottom of drain separator.
1. Open the drain valve slowly, and check that water
in the tank is drained from drain pipe.
2. After water is drained and the air is discharged in
the tank, tighten the drain valve firmly.
3. Loosen the drain handle on the bottom of drain
separator. Check that water in the drain separator
is discharged from the drain pipe.
4. Close the drain handle after draining water firmly.
Note: If the s pecification of air tank
contents of this opera tion manual, follow the
manufacturer's operation manual.
3-10
"COOLANT" (6-1). For the coolant capacity, refer t o
differs from the

"MAIN SPECIFICATIONS"

Reset button
Signal
(red)

Fig. 3-15 Air Cleaner - Check for Clogging

Drain valve
Drain
pipe
Fig. 3-16 Air Tank - Drain Water
(12-1).
Drain
separator
Drain
handle