Hibernation Mode; Symptom-To-Fru Index - Lenovo ThinkPad Edge E330 Maintenance Manual

In certain circumstances, the computer goes into sleep mode automatically:
• After a period of inactivity specified in power plan settings
• When the battery indicator blinks orange, indicating that the battery power is low
To cause the computer to return from sleep mode and resume operation, do one of the following:
• Press the Fn key.
• Open the LCD cover.
• Turn on the power button.
Also, in either of the following events, the computer automatically returns from sleep mode and resumes
operation:
• The ring indicator (RI) is signaled by a serial device or a PC Card device.
• The time set on the resume timer elapses.
Note: The computer does not accept any input immediately after it enters sleep mode. Wait a few
seconds before taking any action to reenter operation mode.

Hibernation mode

In hibernation mode, the following occurs:
• The system status, RAM, VRAM, and setup data are stored on the hard disk.
• The system is powered off.
To cause the computer to enter hibernation mode, do the following:
If you have defined one of the following actions as the event that causes the system to go into hibernation
mode, perform that action.
• Closing the lid.
• Pressing the power button.
Also, the computer goes into hibernation mode automatically after a period of inactivity specified in power
plan settings
When the power is turned on, the computer returns from hibernation mode and resumes operation. The
hibernation file in the boot record on the hard disk drive is read, and system status is restored from the
hard disk drive.

Symptom-to-FRU index

This section contains following information:
• "Numeric error codes" on page 36
• "Error messages" on page 36
• "No-beep symptoms" on page 37
• "LCD-related symptoms" on page 37
• "Intermittent problems" on page 37
• "Undetermined problems" on page 38
The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most
likely cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the sequence shown in the column headed "FRU or
action, in sequence." If replacing a FRU does not solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
.
Chapter 4 Related service information
35