Jonsered FC2256W Operator's Manual page 34

Temperature -5°C or colder
Dismantle the machine's wear guard, and fit the wear
guard from the winter kit as shown in the figure. Pay
particular attention that the opening on the air duct is
positioned in the centre of the hole in the air filter holder.
IMPORTANT! If the temperature rises above -5°C or
0°C respectively the machine MUST be restored to its
normal set-up. Otherwise there is a risk of overheating,
which can cause severe engine damage.
IMPORTANT! Any maintenance other than that
described in this manual must be carried out by your
servicing dealer (retailer).
Lubrication of wire
NOTE!
The wire is pre-lubricated and does not need to be
lubricated again until required.
• Remove the protective cover.
• Unscrew the cylinder cover and make sure the rubber
bellows on the wire has not been expanded too much.
34 – English
MAINTENANCE
• Unscrew the plug on the grease nipple.
• Use antifreeze spray with a 2 mm spray tube.
• Fit covers.