AstroStart 4204 User Manual page 14

SECONDARY FUNCTIONS
ANTI-LOCK
When connected to ignition key cylinder, this function prevents system from locking the doors during automatic
rearming if key is in the ignition.
It can also be connected to a switch to select automatic locking as ACTIVE or INACTIVE.
TEMPORARY VALET MODE (ALARM)
This mode is used to cancel automatic rearming for an indefinite period of time.
You will find this mode useful when fuelling up or working on your vehicle.
To activate Temporary Valet Mode, press
When light stops flashing, it confirms that Temporary Valet Mode has been activated.
To cancel this mode, place ignition key in "RUN" position then remove it; passive rearming is reactivated when
you open a door.
You can also arm the system using the remote, which cancels Temporary Valet Mode.
V M
ALET ODE
This mode is used to deactivate alarm permanently when you take your vehicle in for
servicing for example. It can be de/activate by the remote (see table of commands, page 5)
or by the Valet switch.
Valet switch activates Valet Mode or terminates alarm condition when your remote control
is not available (lost, batteries dead, etc.).
This switch must be installed in a hidden place known only to regular users of the vehicle.
Ask your installer to tell you where it is.
T V M
O ACTIVATE ALET ODE
indicator light comes on at half-brightness.
T V M
O DEACTIVATE ALET
until indicator light goes out.
Notes:
If you perform both sequences one after the other, you need to pause for 3 seconds between the two
sequences.
Valet Mode is automatically deactivated when key is turned to the "ON" position for the tenth time. This is to
prevent Valet Mode from being left on for long periods of time.
GLOSSARY
S
IREN
Siren has six different sounds, i.e., it chirps repeatedly and has six different melodies.
It chirps intermittently (short repeated chirps) during a pre-alarm and continuously during an alarm condition.
It can confirm arm and disarm commands with short chirps; see table in CONFIRMATION section.
This function is programmable as active or inactive during installation.
H
ORN
Horn beeps intermittently (short repeated beeps) during an alarm condition.
This function is optional and may require the installation of additional material.
Ask your installer for more details
12
button during rearming cycle (indicator light flashes rapidly).
, place ignition key in "ON" position then press Valet switch (for about 3 seconds) until
, place ignition key in "ON" position then press Valet switch (for about 3 seconds)
ODE
.