Inserting The Ca Card Into The Ci Module; Checking Signal Strength - Sharp Aquos LC-32LE700E Operation Manual

Quick guide
Checking signal strength and
channel strength (DVB-T/C)
If you install a DVB-T/C antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking the
antenna setup screen.
1 Press @ and the "MENU" screen
displays.
2 Press c/d to select "Setup".
Press a/b to select "Antenna setup-
3
DIGITAL", and then press ;.
E

Checking signal strength

Press a/b to select "Signal strength", and
then press ;.
Supply voltage
Signal strength
Channel strength
CH no.
Signal strength
Quality

Inserting the CA card into the CI module

In order to receive coded digital stations, a common interface module (CI module) and a CA card must be inserted in the
CI slot of the TV.
1 Carefully insert the CI module in
the CI slot with the contact side
forward.
2 The logo on the CI module must
be facing outward from the rear
of the TV.
LC-LE700E_GB3.indd 11 LC-LE700E_GB3.indd 11
Current Max.
Current Max.
Checking CI module information
Go to "MENU" > "Digital setup" > "CI menu".
• The content of this menu depends on the provider of the CI module.
Module
General information on CI module displays.
Menu
Adjustment parameters of each CA card displays.
Enquiry
You can input numerical values such as passwords here.
NOTE
• Make sure that the CI module is properly inserted.
• This menu is only available for digital stations.
E
Checking channel strength
Press a/b to select "Channel strength", and
then press ;.
• You can input a specified frequency band using the 0_9
numeric buttons.
Channel strength of DVB-T
Supply voltage
Signal strength
Channel strength
CH no.
Signal strength
Current
Quality
Current
Channel strength of DVB-C
Supply voltage
Frequency
Signal strength
Symbol rate
Channel strength
QAM modulation
Signal strength
Current
Quality
Current
4
Position and align the antenna so that
the maximum possible values for "Signal
strength" and "Quality" are obtained.
NOTE
• The values of "Signal strength" and "Quality" indicate when to
check the appropriate alignment of the antenna.
MHz
Max.
Max.
MHz
Max.
Max.
11
2009/07/13 19:11:29 2009/07/13 19:11:29