Initial Auto Installation - Sharp Aquos LC-32LE700E Operation Manual

Quick guide

Initial auto installation

When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings one
after another.
Confirm the following before turning on
the power
E
Is the antenna cable connected?
E
Is the AC cord plugged in?
E
Is the MAIN POWER switch turned on (;)?
1
Press a on the TV.
• The initial auto installation wizard appears.
2
Setting the OSD language.
Press a/b/c/d to select the desired language,
and then press ;.
3
Selecting the location of the TV.
HOME
Press c/d to select where you will use this TV,
and then press ;.
• HOME: "STANDARD" will be the default value for the "AV
MODE" setting.
• STORE: "DYNAMIC (Fixed)" will be the default value for
the "AV MODE" setting. If the "AV MODE" is changed,
the TV will automatically switch back to "DYNAMIC
(Fixed)" when there is no signal input from the TV or
remote control unit for 30 minutes.
• A demonstration image will be displayed after initial auto
installation is completed. If you have chosen "STORE" by
mistake, go to "Setup" > "Reset" > select "HOME" again.
4
Setting the country.
Austria
Finland
Greece
Press a/b/c/d to select your country or area,
and then press ;.
• This setting screen only appears during the first
installation.
LC-LE700E_GB3.indd 9 LC-LE700E_GB3.indd 9
NOTE
• If you set "Sweden" in the country setting, you can select
the cable provider "ComHem". Refer to the H mark
in the following steps or instructions about the settings for
"ComHem".
5
Starting channel search.
Press c/d to select "Digital search" or "Analogue
search", and then press ;.
•
•
NOTE
• If you turn off the power on the TV while performing a channel
search, the initial auto installation wizard will not appear. The
auto installation function allows you to execute the installation
again from the "Setup" menu (Page 27).
• The initial auto installation wizard will abort if you leave the TV
unattended for 30 minutes before searching for channels.
• After initial auto installation is completed, the default PIN is
automatically set to "1234". To change the PIN setting, refer to
Password/Parental lock settings (Page 30). To clear the PIN
setting (PIN input will no longer be needed), refer to CLEARING
THE PIN (Page 46).
• When "Italy" is selected in the country setting, the default age
STORE
restriction value is set to 18.
Digital broadcast setting
Press c/d to select "Terrestrial" or "Cable",
and then press ;.
H
•
E
Searching for terrestrial broadcasts
The TV searches for, sorts and stores all the
receivable TV stations according to their
settings and the connected antenna.
•
Digital search Analogue search
To watch both analogue broadcasts and digital
broadcasts, you should perform the channel search
setting for each format.
If you want to search for more broadcasts, execute
"Additional search" from the "Programme setup" menu
(Pages 27_29).
Terrestrial Cable
When you set "Sweden" in the country setting and select
"Cable" for the searching format, you can select the
cable provider "ComHem".
To abort the initial auto installation in progress, press 6.
9
2009/07/13 19:11:28 2009/07/13 19:11:28