Vcr And Satellite Receiver Installation - Panasonic TC-14B3R Operating Instructions Manual

VCR AND SATELLITE RECEIVER INSTALLATION

Your new TV is supplied with programme position ' 0' set to receive an RF signal from a VCR.
However, if for some reason the VCR is tuned to a different RF channel then you will not receive any picture or sound from the VCR on
programme position ' 0' of the TV. It will be necessary to either adjust the RF channel of the VCR or to adjust the tuning of the TV' s
programme position ' 0' or both until the RF output channel of the VCR is received.
It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment.
TO TUNE YOUR VCR TO THE TV
RF CHANNEL ADJUST
Note :
Some VCR' s are capable of adjusting their
RF channel via their remote control unit.
If you are going to use a Satellite Receiver and a VCR, it is important, to avoid tuning problems, that they are both tuned to output their
signals on different channels. For example, if your VCR is tuned to output channel 32, your Satellite Receiver could be set to output
channel 34. Refer to your Satellite Receiver and VCR instruction books for precise tuning information.
recorded tape
programme
rear of
VCR
See below for
installation of VCR
Satellite Receiver
TO TUNE YOUR TV TO THE VCR
Insert
and select
playback
Access the Manual tuning menu as
detailed on page 9.
Programme position is displayed top left
Set TV to
of screen
? ? To select programme position ' 0' (VCR)
position ' 0'
-
VCR
Adjust
tuning
Operation
completed
and
+ To start search for VCR playback
VCR
Manual Tuning
: Programme Position
- /+ : Start Search
TV/AV : . Store
F : Previous Menu
N : Exit
21
TV/AV
TV/AV
To store position
N
N
To return to
viewing screen
69
11