Mazda 2009 Mazda3 4-Door Owner's Manual page 228

Interior Comfort
Audio System
(How to clear the message)
Press any of the following FM/AM,
l
SAT, CD, MEDIA, CAT, ESN/DISP,
Instant replay, POWER buttons.
Turn the ACC off or insert a CD.
l
Change a channel.
l
NOTE
If an ID code is not input for 10 seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.
Lock cancellation
Setting condition: SAT mode
(Releasing a locked channel)
1. Select a channel to be released by
pressing the category button. Example:
Select the locked channel (i.e. 100). At
this time, SR1 LOCK 100 is
displayed.
(Registered ID code input preparation)
2. Hold the scan button, then press
channel preset button 6, hold both
buttons together for 1.5 seconds.
3. ENTER PIN appears for 2 seconds
which indicates that it is in code input
mode.
4. SR1 - - - - appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is 2323 ,
input 2323 . At this time SR1 2323
is displayed. Press the scan button after
the code is input.
6-44
NOTE
If "Err" is displayed, go to the
"INITIALIZATION OF ID CODE" section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the scan button briefly.
7. If it does not match the registered code,
SR1 Err is displayed and then it
returns to SR1 - - - - .
8. If it matches the registered code,
SR1 UNLOCK appears for 3
seconds which indicates that the code
input has been completed.
9. SR1 100 appears which indicates that
the parental lock is off. At this time,
sound is heard.
(How to clear the message)
Press any of the following FM/AM,
l
SAT, CD, MEDIA, CAT, ESN/DISP,
Instant replay, POWER buttons.
Turn the ACC off or insert a CD.
l
Change a channel.
l
NOTE
If an ID code is not input for 10 seconds,
l
"Err" is displayed and it returns to the
former display.
Channel preset buttons 1, 2, 3, 4 and the
l
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.