Table of Contents
Advertisement
Mazdaspeed6_8V77-EA-06F_Edition1 Page248
Tuesday, May 9 2006 10:45 AM
In Case of an Emergency
Emergency Starting
Connect cables in numerical order and disconnect in reverse order.
1. Make sure the booster battery is 12 V
and that its negative terminal is
grounded.
2. If the booster battery is in another
vehicle, don't allow both vehicles to
touch. Turn off the engine of the
vehicle with the booster battery and all
unnecessary electrical loads in both
vehicles.
3. Connect the jumper cables in the exact
sequence as in the illustration.
Connect one end of a cable to the
l
positive terminal on the discharged
battery (1).
Attach the other end to the positive
l
terminal on the booster battery (2).
Connect one end of the other cable
l
to the negative terminal of the
booster battery (3).
Connect the other end to a solid,
l
stationary, exposed metallic point
(for example, the strut mounting
bolt) away from the discharged
battery (4).
7-16
Form No.8V77-EA-06F
Jumper cables
Booster battery
Discharged
battery
4. Start the engine of the booster vehicle
and run it a few minutes. Then start the
engine of the other vehicle.
5. When finished, carefully disconnect the
cables in the reverse order described in
the illustration.
Black plate (248,1)
Advertisement
Chapters
Table of Contents
