Thermostat Control; Ventilation Control - GE Heat Pump Zoneline 2700 Series Use And Care Manual

PROBLEM
AIR CONDITIONER
DOES NOT OPERATE
AIR CONDITIONER
"DOES NOT COOL
OR HEAT AS IT
SHOULD"
"BURNING" ODOR
AT START OF
HEATING
OPERATION
OPERATING SOUNDS
DISCHARGED AIR
CONDENSES ON
WINDOWS OR
WALLS
If you need more help.. call, toll free:
GE Answer Center@
800.626.2000
consumer information service
POSSIBLE CAUSE AND REMEDY
cord not plugged in, fuse blown, or circuit breaker tripped.
Unit is waiting 3 minutes for pressure to equalize across the compressor.
Curtains, blinds or furniture blocking front of air conditioner will restrict air flow.
Thermostat Control may not be set high enough. Turn control to a lower or higher
number.
. Air filter dirty, should be cleaned at least every 30 days. See instructions on page 5.
Room may have been very
Allow time for it to cool down or warm up.
returns.
Ventilation Control may be set at OPEN position, allowing outside air to enter
the room.
Position of the louvers will affect temperature. See page 3.
can cause "burning" odor at beginning of heating operation. This odor should
Relay clicks may be heard when compressor or fan cycles on and off. This is normal.
. Fan runs continuously when air conditioner is operating except when Fan Cycle
Switch behind room cabinet is set at ~CLE. Then the fan cycles on and off with the
compressor or resistance heater.
Tilt louvers down slightly and keep them down until condensation disappears.
hot or very cold when air conditioner was first turned on.
6