Editing Dial Plans - Cisco SPA2102 Administration Manual

Configuring Dial Plans
STEP 1
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business ATA Administration Guide

Editing Dial Plans

You can edit dial plans and can modify the control timers.
Start Internet Explorer, and then enter the IP address of the SPA9000. Click
and then click
Entering the Line Interface Dial Plan
This dial plan is used to strip steering digits from a dialed number before it is
transmitted out to the carrier.
Connect to the administration web server, and choose Admin access with
Advanced settings.
Click Voice tab > Line , where N represents the line interface number.
Scroll down to the Dial Plan section.
Enter the digit sequences in the Dial Plan field. For more information, see
Dial Plans,” on page
Click Submit All Changes.
Resetting the Control Timers
You can use the following procedure to reset the default timer settings for all calls.
If you need to edit a timer setting only for a particular digit sequence or type of call,
you can edit the dial plan. See
Connect to the administration web server, and choose Admin access with
Advanced settings.
Click Voice tab > Regional.
Scroll down to the Control Timer Values section.
Enter the desired values in the Interdigit Long Timer field and the Interdigit Short
Timer field. Refer to the definitions at the beginning of this section.
.
56.
“About Dial Plans,” on page
4
“About
56.
65