Diagnostic Codes; Washer Help Mode - Maytag MAH22PDAGW0 Installation Instructions Manual

5. Quick Overview Test - With the entire display flashing, this
cycle is started by pressing the WOOLENS key pad. This
cycle provides a quick verification that the cold and hot water
valves, dispensers, and pump motor are working, as well as
actuator dispenser movement. It also includes door lock,
drain, and spin operations.
Pressing the DELICATES AND KNITS key pad will exit diagnostic
mode and cancel a diagnostic cycle in process.

DIAGNOSTIC CODES

If the set-up mode is entered and one of the following has
occurred, the appropriate diagnostic code will be in the display.
d5 Blocked coin 1 or coin drop control circuit failure (coin
recognition and price display disabled while blockage
persists). PN Models Only: Set-up mode J. should be
set to _d (or Ed if in free operation mode) to eliminate
coin related diagnostic codes.
d9 Low voltage detected for 8 seconds.
d13 Blocked coin 2 or coin drop control circuit failure
(coin recognition and price display disabled while
blockage persists).
F20 Slow Fill. The washer will not detect water input for
4 min. Pressure switch failure or no water inlet. This
code is reported as d8 on d7.
F22 The door is not able to lock. Door lock error or
someone trying to start the washer, by pressing the
door switch with the finger. This code is reported as
d17 on Accu Trac.
(For different code consult service personnel)
14

WASHER HELP MODE

This mode is entered by pressing the PERMANENT PRESS key
pad while in special pricing option mode 2.XX (or while dAS
displays if operating with Maytag Data Acquisition set-up).
In help mode, other display symbols and elements are mapped
to reflect the state of various inputs and outputs as follows:
Display Symbol
Wash
*
° (Circle above digit)
DOOR LOCKED
COLD
HOT
OR
AVAILABLE
Description
Water sensed at wash level.
Low voltage present (below about
90 VAC).
Door closed.
Door sensed locked.
Cold water relay on.
Hot water relay on.
Door unlock.
Drain pump ON.