Electrolux 30" Service Manual page 30

3. Remove template and place brackets on floor
with turned up flanges to the outside (see figure
10). Line up holes in brackets with marks on
floor and attach with 4 screws provided (2
screws per bracket). Brackets must be secured
to solid floor. If attaching to concrete floor, first
drill 3/16" (4.8 mm) dia. pilot holes using a
masonry drill bit.
4. Level range if necessary, by adjusting 4 leg
levelers with wrench. (See Figure 11). A
minimum clearance of 1/8" (3.2 mm) is required
between the bottom of the range and the rear leg
levelers to allow room for the anti-tip brackets.
5. Slide range into place making sure rear legs are
trapped by ends of brackets. Range may need
to be shifted slightly to one side as it is being
pushed back to allow rear legs to align with
brackets.
6. After installation, verify that the anti-tip bracket
is engaged. Open and remove drawer and
check to make sure the anti-tip bracket is
engaged.
Figure 11
30