Terminal block
Removing the end caps:
1. Disconnect power and roll the control mounting
panel forward.
2. Remove one screw from the top and one screw from
the inside which prevents the end cap tabs from
releasing from the control mounting pan. Lift the end
cap up and off.
Top
Removing the bottom glass trim:
1. Disconnect power and remove one end cap.
2. Remove the two screws holding the trim to the control
mounting panel.
Two screws
Removing fluorescent light socket:
1. Disconnect power, roll the control mounting panel
Inside
106
forward and remove the bottom glass trim.
2. Squeeze the tabs on the sides of the socket and
push it through the control mounting panel.
Tab on each side
Main top area:
Removing coil elements and drip pans:
1. Raise the end of the element about an inch and pull
the element out. The drip pan then lifts out.
Element and drip pan
Raising main top: (smooth top models)
1. Disconnect power and open the oven door.
2. Remove the two screws holding front of the top to
the front frame and lift the front of the top up.
Two screws
Removing the elements: (Smooth top models)
1. Disconnect power and raise the main top.