Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
5.2
Installing Drive Enclosures
Optional drive enclosures can be installed while the ETERNUS DX Disk storage system is run-
ning without affecting the system.
This section explains how to install optional drive enclosures.
5.2.1
Installation Rules for Drive Enclosures
Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Drive enclosures cannot be connected to 2.5" type controller enclosures.
5.2.2
Installable Drive Enclosures
For installable drive enclosures, refer to "Product List".
5.2.3
Drive Enclosure Handling Instructions
■
About condensation
■
About static electricity
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Do
CAUTION
•
When moving a drive enclosure from a cold place, such as an un-
conditioned store house in winter, to a warmer place such as an air-
conditioned room, the severe temperature change may result in
condensation forming.
To avoid this, allow the packed drive enclosures sufficient time in the
warmer place (one hour for each 15C of temperature difference) to
adapt to the new temperature.
Do
CAUTION
•
When handling drive enclosures, make sure to wear a wrist strap or
touch a metal part to discharge the human body's natural static
electricity. Failure to discharge static electricity may cause device
failure.
Copyright 2014 FUJITSU LIMITED
63
P3AM-5512-07ENZ0