Bosch DCN Next Generation Operation Manual page 222

222 en | Configuration
2.
3.
Notice!
Some installation mode screens affect all interpreter desks in the system, only one interpreter
desk at a time can be in the installation mode.
4.
Navigation in the installation mode
In the installation mode, only a small number of controls are available (refer DCN-IDESK
Interpreter Desks, page 50).
Control
Primary knob
Preselect channel button a
Preselect channel button b
Preselect channel button d
Preselect channel button e
Output selection button B
Table 7.40: Controls in the installation mode
Configuration procedures
To select the necessary parameters in the installation menus to configure the interpreter desk
do as follows:
1.
2.
3.
Menu screens
Menu a
Menu a sets the display language of the interpreter desk when in the installation mode. The
language is set for all interpreter desks in the system.
Menu b
2013.11 | V2.0 | DCN-NG_OM_V4.x
Push the b preselect channel button and the B output selection button at the same time.
The installation mode of the interpreter desk starts.
The display shows:
When one of the interpreter desks in the system already is in the installation mode, the
display shows:
Push the a and b preselect channel buttons to go to the necessary installation menu. The
parameter that is set has square brackets, for example, [option].
Push the d preselect channel button to clear the set parameter. The square brackets
change to arrow brackets, for example, <option>. This shows that you can select a
different choice with the primary knob.
Turn the primary knob to go to the necessary parameter. When the correct parameter is
selected, push the e preselect channel button. The arrow brackets change to square
brackets.
Function
Select menu option(s)
Go to the previous menu
Go to the next menu
Clear current selection
Enter current selection
Exit the installation mode
Operation Manual
Conference System
Bosch Security Systems B.V.