Bosch DCN Next Generation Operation Manual page 195

Conference System
Menu item
2C
Table 7.18: Monitoring sub-menu (* = default)
Setup
Use the 4 Setup menu item to open the Setup sub-menu. Use the menu items in this sub-menu
to configure the digital audio expander.
Notice!
To open the Setup sub-menu, you must push and hold the knob for more than 3 seconds.
Menu item
4A AGC
4B Output Mode
4C Routing
4D Unit Name
Bosch Security Systems B.V.
Parameter Value
Audio in / output: Format:
Input 1 * AES/EBU, SPDIF
Input 2 AES/EBU, SPDIF
Parameter Value
Input: AGC:
Input 1L On, Off
Input 1R On, Off
Input 2L On, Off
Input 2R On, Off
Output: Format:
Output 1 AES/EBU*, SPDIF
Output 2 AES/EBU*, SPDIF
Input/output: Channel:
Input 1L --*, 00 to 31
Input 1R --*, 00 to 31
Input 2L --*, 00 to 31
Input 2R --*, 00 to 31
Output 1L --*, PA, 00 to 31
Output 1R --*, PA, 00 to 31
Output 2L --*, PA, 00 to 31
Output 2R --*, PA, 00 to 31
--- Name: Digital
Expander* Custom
name
Operation Manual
Configuration | en
Description
Shows the format of the
digital audio (read-only).
When 'No valid signal' is
shown, the audio input
does not contain a valid
signal.
Description
Sets the automatic gain
control (AGC) of the audio
inputs on and off
The format of the digital
audio for audio output 1
and audio output 2.
The channel that is attached
to the audio input or audio
output of the digital audio
expander. (PA = public
address system.)
The name of the audio
expander (max. 16
characters).
2013.11 | V2.0 | DCN-NG_OM_V4.x
195