Transmission with Destination Monitoring
Select "Monitor" on the Touch Panel Display to obtain a dial tone. This feature is called "On-hook
dialling". To monitor the status of a remote station, follow the steps below.
This function is not available when the Function Parameter "137 Re-enter Direct Dial" (Fax/Email Settings >
Fax Parameters) is set to "Valid".
1
Place original(s).
If the Platen Glass is used, only one page
can be transmitted at a time.
Refer to Placing Originals (See page 14).
2
Press the Fax key.
3
Select "Monitor".
The Monitor screen appears, and you will hear
a dialling tone through the monitor speaker.
4
Enter the fax number of the
destination.
When the Function Parameter "136 Restrict
Direct Dial" is set to "Valid", manual input of
fax numbers is not available. Select a
destination from the "Address Book".
Raises the monitor volume.
Lowers the monitor volume.
Select once to recall the last
dialled fax number.
Select twice to insert a pause
(dialling interval).
5
When you hear a beep, press the
Start key.
For instructions on how to cancel a
transmission, refer to Cancelling a
Communication (see page 53).
Press the Reset key to return the machine
to the initial screen of the current active
mode.
31