Panasonic DP-C406 Operating Instructions Manual page 218

Info. Code
505 Received the polling request
when documents have not
been stored for being polled.
540/541/542/ Communication error occurred
543 while transmitting.
550 Telephone line disconnected.
554/555 Communication error occurred
while receiving.
580 Sub-address transmission to a
unit that has no Sub-address
function.
581 Sub-address Password
transmission to a unit that has
no Password Sub-address
function.
623 No document is loaded in the
ADF.
630 Redial was not successful due
to a busy line.
634 Redial was not successful due
to no response from the called
station or wrong number
dialled.
If a dial tone is not detected,
the machine does not
transmit.
If busy tone was not
detected, the machine will
only redial once.
638 Power failure occurred during
the communication.
700 During dialling, the Stop key
was pressed.
711 Incorrect LDAP settings
712 Incorrect Email address
714 Cannot log on to the LAN.
715 TCP/IP connection timed out.
218
Problem
Check with the other party.
Reload the document and send again.
Check with the other party.
Check with the other party.
Check with the other party.
Check the remote station.
Check the remote station.
Resend the documents.
Reload the document and send again.
Check the telephone number, and send again.
Change the setting of the Function Parameter "68
Dial Tone Check" (Fax/Email Settings > Fax
Parameters) to "Off".
Check the power cord and plug.
Reload the document and send again.
Check the LDAP server name, LDAP log-in name,
LDAP password, and LDAP search base.
Check the registered Email address.
Check the IP Address of the SMTP server with the
network administrator.
An unexpected LAN problem occurred. Check the 10
Base-T/100 Base-TX/1000 Base-T cable connection.
Contact the network administrator.
Check the Internet Fax parameter settings.
Verify the IP Address, Default Gateway IP Address,
and SMTP server IP Address.
Action Refer to
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)