Panasonic DP-C406 Operating Instructions Manual page 219

Info. Code Problem
716 Cannot log on to the
designated SMTP server.
717 Incomplete SMTP Protocol
transmission. SMTP server's
hard disk may be full.
719 Received data via LAN is in a
format that is not supported.
720 Cannot connect to the POP
server (incorrect POP server
IP Address). POP server is
down.
721 Cannot connect to the POP
server (user name or
password error).
722 Failed to obtain IP Address
from the DHCP server.
725 DNS server connection timed
out. DNS server is down.
726 Received an error response
from the DNS server.
727 Communication error occurred
while communicating with
remote station.
728 Communication error occurred
with the SMTP Direct
transmission.
729 Failed to authenticate (SMTP
Authentication) when
connecting with the SMTP
server.
730 Cannot retrieve the Journal or
program the Internet
Parameters and the Auto
Dialler remotely via Email from
a PC.
731 The dialler buffer for manual
dialling was full (70 stations)
when the Relay transmission
request was received.
734 Internet Fax communications
and POP reception functions
are disabled.
Action
Check the SMTP server IP Address setting.
Contact the network administrator.
SMTP server is defective.
Contact the network administrator.
Ask the originator to re-send with a supported file
attachment format:
• In the TIFF-F format
• Image data conforming to recording paper size
Check the POP server IP Address.
Contact the network administrator.
Check the POP user name and password, or the
APOP settings.
Contact the network administrator.
Check the 10Base-T/100Base-TX/1000Base-T cable
connection.
Confirm that the Internet Parameter, and the DHCP
server are correctly configured before turning on, or
turning off the power.
Contact the network administrator.
Check the DNS server IP Address.
Contact the network administrator.
Check the POP server name.
Check the SMTP server name.
Check the remote station.
Check the remote station.
Check the SMTP authentication user name and
password.
Contact the network administrator.
Check that the Fax Parameter "158 PC Remote
Update" is set to "Valid".
Request the originator to re-send the Relay
transmission request after the reserved
communication is finished.
Contact the device administrator.
Refer to
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Function
Parameters)
219