C1 Initialising The Voip Gateway Card - Panasonic KX-TDA0490 Getting Started

C1 Initialising the VoIP Gateway Card

C1 Initialising the VoIP Gateway Card
In case you have forgotten, for example, the IP address or log-in password you set to the VoIP
Gateway Card, follow the procedure below to return the settings of the card to the factory default.
Note
Resetting the card will restore all settings, not just the IP address and log-in password, to the
factory default.
1.
Install the card to the PBX, and then turn on the power to the PBX.
Power Switch
2.
Using the Maintenance Console, confirm that the card is in service (INS).
3.
Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
CAUTION
Do not press the Reset Button nor turn the power off then on while the System Initialise
Switch is in this position. Doing so will initialise the PBX.
4.
Using the Maintenance Console, set the status of the card to OUS, then set it back to INS.
64 Getting Started
Reset Button
RESET
SYSTEM
INITIALIZE
NORMAL
System Initialise Switch