Panasonic KX-TDA0490 Getting Started page 134

3.3 Data Management
4.
Click REBOOT to start up the card with the updated page.
You will see a reboot confirmation screen.
5.
Click REBOOT again.
Notice
Please note that rebooting the card does not finish the upload operation. The startup page
will be updated only temporarily for confirmation purposes.
6.
Click Login Screen to continue the upload operation.
The card has rebooted with the new firmware data temporarily so that you can confirm the result
of the upload operation.
At this point, the firmware status of the updated page is "NEW". To complete the upload
operation, you must proceed to the next step and change the status to "Main Operation Mode".
(If you do not, the card will start up with the old firmware data after the next reboot.)
7.
Switch the firmware status of the updated page from "NEW" to "Main Operation Mode", referring
to "3.3.2 Handling of Firmware Page".
The following is an example of the screen where the updated page has been set to "Main
Operation Mode". To set the updated page as the active page on startup, you must apply this
setting.
64 Programming Guide