Starting up the system with system data programmed by Maintenance PC, or using the
saved data.
After installing the optional cards required, execute the following procedures.
MODE=4
Power ON reset or Press
the RESET button
"OFF-LINE" LED flashes
Upload system data
Press the RESET button
Notes
• System programming from Maintenance PC can be done in on-line mode.
• When "OFF-LINE" LED flashes, system start-up is completed. After this, system
programming from the Maintenance PC can be done.
Installation Manual
START
Off-line Mode
SYSTEM=0
On-line Mode
MODE=0
SYSTEM=0
END
Installation
169