Chapter 15: PC Function
15-1 Outline
The PC function is designed to create a ladder circuit program based on the data (coordinates,
distance, degree of match, and results of numerical calculations) obtained from the measurements
and calculations made by the IV-S30J. Then it outputs the results of the calculations performed by the
circuit.
Use of the PC function enables the IV-S30J to output measurement results to an external equipment
such as a lamp by itself, without the need for an external PC.
15-2 Operation cycle
The operation cycle of the IV-S30J is outlined below. This flowchart contains only the operations
related to the PC function, and does not show communications with external devices.
Ladder circuit calculation (final output conditions)
Image processing for measurement 0 using camera 1
(based on output conditions for measurement 0 of camera 1)
Measurement processing for measurement 0 using camera 2
(based on output conditions for measurement 0 of camera 2)
Ladder circuit calculation (based on output conditions for measurement 1)
Ladder circuit calculation (based on output conditions for measurement 2)
Ladder circuit calculation (based on output conditions for measurement 3)
Ladder circuit calculation (based on output conditions for measurement 4)
Power ON
Power ON sequence
Input refresh
Y00
X0
C000
Ex. :
X1
Y01
C001
Output refresh
Has a measurement start
input signal been received?
YES
Ladder circuit calculation
Ex. :
C000
0M0
N01
N02
C001
0X0
C000
Ladder circuit calculation
Measurement processing for measurement 1
Measurement processing for measurement 2
Measurement processing for measurement 3
Measurement processing for measurement 4
15-1
PC Function
PC scan
cycle
NO
Measurement
processing
cycle
15