Chapter 7 Setup
>
7.2 Basic Setup
8
8-1
8-2
8-3
7.2.2
Configuration Wizard
Perform the settings necessary for device operation using the [Configuration Wizard] menu on
the [Easy Setup] tab.
Perform the settings in the following order.
•
Create RAID Group
•
Create Volume
•
Define Host
•
Configure Affinity Group
•
Define LUN Mapping
P3AM-3042-06ENZ0
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Finish the initial setup.
Click the [Finish] button.
Figure 7.11 [Finish] screen of the initial setup
The [Initial Setup] completes.
Device setting operation cannot be continued if the IP address is
IMPORTANT
changed. Logon again with the new IP address is required.
Remove the LAN cable (for operation management) from the PC, and connect the LAN
cable (for operation management) of the MNT port of Controller 1 (CM#1) and
Controller 0 (CM#0) to the customer's network.
Start the Web browser, and logon again with the new IP address to perform the config-
uration settings of the ETERNUS DX60/DX80/DX90 using Configuration Wizard.
149
End of procedure
Copyright 2010 FUJITSU LIMITED