Chapter 6
This chapter explains how to connect various cables to the ETERNUS DX60/DX80/DX90.
6.1
Connection Preparation
The following preparations are required before connecting cables:
•
Networking equipment
•
Power related checks
•
Remote support environment condition checks
•
Related manuals
Networking equipment
Prepare the networking equipment to be connected to the ETERNUS DX60/DX80/DX90
Networking equipment (such as a Fibre Channel switch and switching hub)
Power related checks
Refer to
supply facilities meet the specified requirements.
Number and specifications of the power outlets
P3AM-3042-06ENZ0
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Cable Connection
Do
CAUTION
•
Make sure to wear a wrist strap before starting each operation, as
failure to discharge static electricity may cause a device failure.
Do not remove it until the operation is complete.
•
When the disk is brought from a cold to a warm place, there is a
chance that the change in temperature can result in condensation
forming on the magnetic platters. Wait for the disks to warm up to
the local ambient temperature before turning the ETERNUS DX60/
DX80/DX90 on.
"5.1.2 Check the Number of Wall Outlets" (page 87)
106
and check that the available power
Copyright 2010 FUJITSU LIMITED