Show Mvr - Nokia ESB26 User Manual

21.
Example
See the examples below.
no mvr
The no mvr command, in Interface Configuration mode, removes the MVR configuration
from the specified port.
Command Syntax
device-name(config-if UU/SS/PP)#no mvr
Examples
1. The following example shows how to configure port 1/1/1 as an MVR receiver port:
device-name(config)#interface 1/1/1
device-name(config-if 1/1/1)#mvr type receiver
2. The following example shows how to configure Ethernet port 1/1/1 as an MVR source
port:
device-name(config)#interface 1/1/1
device-name(config-if 1/1/1)#mvr type source
3. The following example shows how to remove port 1/1/1 as an MVR port:
device-name(config)#interface 1/1/1
device-name(config-if 1/1/1)#no mvr group
MVR Show Commands
Table 21-3 summarizes the MVR show commands.
Table 21-3 MVR Show Commands
C o m m a n d

show mvr

show mvr interface
show mvr members
show mvr
The show mvr command, in Privileged (Enable) mode, displays the following information,
with regard to the switch:
•
MVR status (enabled or disabled)
MN700004 Rev 01
Multicast VLAN Registration (MVR)
D e s c r i p t i o n
Displays configured MVR parameters with regard to the switch.
Lists the current MVR configurations and status per MVR ports.
Lists the current MVR configurations and status per MVR groups.
262