Conettix Communications Receiver/
Gateway
9.
10. Press Enter. The Setup Mode information appears.
12.5.5
Configuration Using Telnet
1.
2.
3.
Notice!
The Gateway IP is required only if you are connecting to a WAN. In a LAN, the Gateway IP is
i
usually not needed unless the Gateway IP of the PC is different from the Gateway to which
the D6100i is connected.
4.
Host Bits
1
2
3
4
5
6
7
8
9
10
11
Bosch Security Systems, Inc.
Type open <IP ADDRESS> 9999 and press Enter (for example, open 172.17.10.70 9999).
Type 0 (zero) and press Enter to set up the basic server configuration.
If the D6100i was previously programmed with an IP address, the address appears in
parentheses.
Type the IP address (for example, 190.200.128.219) and press Enter.
If the Gateway address is required, type y, press Enter] and then type the address and
press Enter. If the Gateway address is not required or if you use DHCP, type n and press
Enter.
The following prompt appears.
If Network needs to be changed from the default, enter the number of bits that
correspond to the netmask your network uses and press Enter. Contact your network
administrator if you need more information about the netmask.
Netmask
255.255.255.254
255.255.255.252
255.255.255.248
255.255.255.240
255.255.255.224
255.255.255.192
255.255.255.128
255.255.255.0
255.255.254.0
255.255.252.0
255.255.248.0
Installation and Operation Guide
Network Communications | en
Host Bits
Netmask
17
255.254.0.0
18
255.252.0.0
18
255.248.0.0
20
255.240.0.0
21
255.224.0.0
22
255.192.0.0
23
255.128.0.0
24
255.0.0.0
25
254.0.0.0
26
252.0.0.0
27
248.0.0.0
67
2012.11 | 08 | 4998122704