Table of Contents
Advertisement
en MoveMode
Positioning the cookware
Caution
Do not place cookware in the middle between the right
and left zones. The cooking zones are not activated
correctly and you do not achieve a good cooking res-
ult.
MoveMode
9 MoveMode
You can use this function to change the power level for
an item of cookware by simply moving it within the
FlexZone. For this, the zone is divided into three areas
with different power levels.
9.1 Positioning and moving the cookware
Only use one item of cookware. The cooking area de-
pends on the cookware used, as well as its size and
positioning.
Each cooking area has a preset power level:
¡ Front section = power level 9.0
¡ Middle section = power level 5.0
¡ Rear section = power level
12
.
8.2 FlexInduction connect
By default, the FlexZone is configured as two separate
cooking zones. Switch on the following function to con-
nect the cooking zones:
Set the cookware down on the cooking zone.
1.
Touch .
2.
lights up. The FlexZone is connected.
a
Notes
¡ You can change the default setting for the FlexZone.
You can find out how to do this in the "Basic set-
tings" section. → Page 21
¡ If you move or lift the cookware from an active con-
nected cooking zone, an automatic search starts.
Each item of cookware that is found within the cook-
ing zone during this search is heated at the previ-
ously selected power level.
8.3 FlexInduction disconnecting
Touch
.
▶
a The cooking zones are separate and work inde-
pendently of each other.
You can change the standard setting for the default
power levels. You can find out how to do this in the
"Basic settings" section → Page 21.
9.2 Activating MoveMode
Requirement: Only place one item of cookware on a
FlexZone.
Select one of the two cooking zones in the
1.
FlexZone.
Touch
.
2.
Select
3.
a
lights up.
a The function is switched on.
Advertisement
Table of Contents
