Table of Contents
Advertisement
Setting the configuration data
CL-S500 can save up to three settings of luminance-Gamma-color as configuration data
within the monitor and they can be switched by selecting a configuration number
appeared on the current operating state OSD screen. The following three configuration
settings are saved prior to shipping as factory default.
Luminance (cd/m
Configuration
number
Max.
1
2
3
* : x0.299, y0.315
To set and save configuration data other than above, an optional
Note
calibration kit is required.
Setting method 1
You can switch the configuration data by OSD.
1) Display the "Operation Button Guide ① " by pressing any one of operation buttons
(A–C).
2) Press the "MENU" button.
3) Select "CONFIGURATION" from MENU 1/2 using the "▼" or "▲" button and press the
"OK" button. Then select "Config1", "Config2" or "Config3" from "CONFIGURATION"
OSD and press the "OK" button.
Setting method 2
You can assign the switching of the configuration data to the function buttons (F1 or
F2) which allows you to switch easily via button operation. The following explains how
to assign to the "F2" button.
1) Display the "Operation Button Guide ① " by pressing any one of operation buttons
(A–C).
2) Press the "MENU" button.
3) Select "FUNCTION" from MENU 1/2 using the "▼" or "▲" button and press the "OK"
button. Then select "FUNCTION2" from "FUNCTION" OSD and press the "OK"
button.
4) Select "CONFIGURATION" from "FUNCTION2" OSD and press the "OK" button.
5) Display the "Operation Button Guide ① " by pressing any one of operation buttons
(A–C).
6) Press the "F2" button to select "Config1", "Config2" or "Config3" from
"CONFIGURATION" OSD.
You can check the "CALIBRATION SETTING" status of "CURRENT STATE".
)
2
Min.
500
0.6
500
1
500
0.6
Color
Gamma
7500 K *
DICOM GSDF
7500 K *
DICOM GSDF
7500 K *
EXP. 2.2
- 16 -
Shipping setting
Japan, Europe, Korea
North America
－
Advertisement
Table of Contents
