Panasonic AlCare TK-AS500 Operating Instructions Manual page 43

Specifications
Rated voltage, frequency, input current
Rated power consumption
Dimensions
Main unit
Weight
Temperature of water used by Alkaline Ionizer
Pressure of water used by Alkaline Ionizer (dynamic pressure) 70 kPa to 350 kPa
Usable water service pressure (static pressure)
Electrolysis method
Output water volume
(flow of water produced)
Electrolysis capability selection
Continuous operation
Electrolysis
capability
Electrolyzer life
Electrolytic cleaning
Purified water output volume
Filtration flow volume
Cartridge Installed In the unit
Purification capacity
Removable substances
Guide for time to replace cartridge
Filter material
Components which cannot be filtered out
Length of power cord
Power protection device
* All figures given are for a water temperature of 20 °C.
* The total volume of water coming out of the main spout, drain hose is given as the run through water volume and daily volume of water used.
* Activated carbon uses powdered activated carbon and granular activated carbon.
(Note1) This period may be shorter depending on the water quality and usage environment.
(Note2) The amount of water that can be used with Alkaline 1 to 3 and acidic water is equivalent to about 83 % of the filtration flow volume (water
purifying capacity).
(Note3) This value is for a removal rate of 80 % based on JIS S 3201 tests.
(Note4) This value is for a filtration flow volume of 50 % based on JIS S 3201 tests.
(Note5) This value is for a removal rate of 80 % based on JIS S 3201 Annex A tests.
(Note6) This value is for a removal rate of 80 % based on specification standard tests (JWPAS B standards) stipulated by the Japan
Water Purifier Association (JWPA).
(Note7) This substance is for a removal rate of 80 % based on specification standard tests (JWPAS B standards) stipulated by the Japan
Water Purifier Association (JWPA). Note that it is not stipulated as part of purification capacity.
(Note8) This period applies when 15 liters of water are used a day. If 30 liters are used a day, the cartridge usage limit will be approximately one-half.
The period may also be significantly less depending on the amount of water used and on its quality and pressure.
220-240 V ~ , 50 Hz, 0.7 A
Approx. 64 W (approx. 0.5 W during standby)
Approx. 168 (W) × 95 (D) × 333 (H) mm
Approx. 2.4 k (approx. 2.8 k when full of water)
Under 35 °C (under 80 °C for bypass selector)
70 kPa to 750 kPa
Continuous electrolysis
2.0 L/min. [at 100 kPa water pressure]
Alkaline: 3 levels; Acidic: 1 level
Approx. 10 minutes at room temperature
Approx. 850 hours cumulative
(ion water production time, cleaning time only)
Auto cleaning method
2.4 L/min. [at 100 kPa water pressure]
2.4 L/min. [at 100 kPa water pressure]
TK-AS500C-EX
Free residual chlorine
Turbidity
Chloroform
Total trihalomethane
Bromodichloromethane
Dibromochloromethane
Bromoform
Tetrachloroethylene
Trichloroethylene
CAT (pesticide)
2-MIB (mold smell)
Soluble lead
1,2-DCE
Benzene
Geosmin (mold smell)
Phenols
PFOS and PFOA
Iron (particulate form)
Aluminium (neutral)
Approx. 2 years
Non-woven fabric, activated carbon, ceramic, hollow fiber membrane
Iron dissolved in water, heavy metals (silver, copper, etc.), salt (seawater)
Approx. 3 m
Current fuse: 2.5 A
* This product cannot convert hard water into soft water.
(Note 1)
(Note 2)
12 000 L (Note 2,3)
12 000 L (Note 2,4)
(Note 2,5)
12 000 L
12 000 L (Note 2,5)
12 000 L (Note 2,5)
(Note 2,5)
12 000 L
12 000 L (Note 2,5)
12 000 L (Note 2,5)
(Note 2,5)
12 000 L
12 000 L (Note 2,3)
12 000 L (Note 2,3)
(Note 2,3)
12 000 L
12 000 L (Note 2,5)
12 000 L (Note 2,5)
(Note 2,3)
12 000 L
12 000 L (Note 2,3)
12 000 L (Note 2,6)
(Note 7)
Can be removed
Can be removed (Note 7)
(Note 8)
EN43