Table of Contents
Advertisement
Operating Procedure
The operating procedure for assembly program 4 is as follows:
1.
Mount the DATANET-30 Systems Tape on handler 1, plug
1.
If
General Assembly
program 4 is to be run from cards, place General Assembly Program 4 program in
the card reader.
2.
Place old master tape to be updated on handler 2, plug
1.
If
a new tape is to be gener-
ated, place a working tape on handler 2, plug
1.
3.
Place a good tape with a write-permit ring on handler 3, plug
1. This is the new master.
4.
If
General Assembly Program 4 is to be run from systems tape, place a General Assem-
bly Program 4 call card followed by the updating deck in the card reader.
If
General
Assembly Program 4 is to be run from cards, place the updating deck behind the General
Assembly Program 4 program deck.
5.
Depress LOAD CARD, RESET ALARM, RESET P, and START.
6.
If
DATANET-30 General Assembly Program is to be run following General Assembly
Program 4, place the following console switches down:
Switch
1.
This calls in DATANET-30 General Assembly Program after completion
of General Assembly Program 4.
Switch 16.
This switch is pertinent to DATANET-30 General Assembly Program
only.
It
indicates that the source program is on tape 3.
For other switch settings see DATANET-30 General Assembly Program operating instructions.
[IDruuru~~u~ ~@------------
A-17
Advertisement
Table of Contents
