4.
INSTALLING OPTIONAL ACCESSORIES
4-2. PANEL SEPARATION KIT (PG-4K/4L)
4-1. CTCSS unit (TSU-7)
1. Remove the four screws holding the top cover.
2. Remove the top cover.
3. Insert the TSU-7 into the specified connector.
Install
it on the PC board under the flat cable on the front
left side, as viewed from the panel.
4. Install the top cover.
Dey
See
OOAONDA
KW
Press the release button on the left of the front panel.
. Hold the left side of the front panel, and slowly pull
the panel forward.
. Remove the connector cover on the chassis side.
. Disconnect the connector, and pull the cord out.
. Remove the connector cover on the front panel side.
. Remove the connector, and pull the cord out.
. Install the panel separation kit.
. Fit the cord grommet into the groove.
. Reinstall the connector covers on the front panel and
chassis.
Release button
@®