Using The Dtss Function - Kenwood TM-732A Instruction Manual

2-6 Using the DTSS Function
Press the BAND SEL key to select the desired band.
MSO20 |.
a
© Memory channel |
Call the memory channel containing the data.
©) Call channel
Press the CALL key.
OVO |
Press the F key, then | press the SHIFT/ DTSS key
within 10 seconds. The DT indicator lights.
rent Sad Gens ee 1
64
©) Transmit operation
When the PTT switch is pressed on the microphone the
selected code group will be transmitted. It will take
about 1/2 second to transmit the 3 tones. The
microphone will be muted while the tones are being
transmitted.
©) Receive operation
The squelch will now remain closed until the correct
code group is received.
When a Signal matching the programmed code is
received, the squelch opens. If no signal is received
from the other transceiver for two seconds or more after
the squelch turns on, the squelch turns off.
Use of noise squelch is recommended when using
DTSS.
Notes
1. DTSS for two bands can be turned on at the same time, but the
first signal may not be received.
2. If the receiving transceiver is in the battery save mode, the DTSS
code may not be received. To be sure the signal is received,
transmit it for several seconds, release the PTT key, and transmit
again.
3. If S meter squelch is used, DTSS cannot be received if the signal
is not stronger than the set level.