Table of Contents
Advertisement
34
10 Language setting
• Activate the programming mode: Press STOP + SUN + BUTTERFLY. Press the Stop button first and then the pro-
gram selection buttons simultaneously. The display lights up and shows "ACCESS 1000". To be able to move on,
code 9191 must replace the code 1000.
• After the above, you will be at the first digit "1" in ACCESS 1000. Step to the digit "9" using the program selection
buttons SUN (up) or BUTTERFLY (down). Then move to the next digit, in this case "0", using the STOP button. In-
crease this to "1" using the SUN button and then continue until "9191" is shown. Once you have set the last digit,
press the STOP button and access programming mode.
• The first parameter and the factory-set value are then shown in the display. The row with the parameter flashes.
• Step forward or back with the SUN (increase) or BUTTERFLY (decrease) button until "P 105" is shown.
• Once the display shows "P105", press STOP to confirm. The row below will now flash with the language symbol.
Each language is assigned a number symbol as listed in the following table. The unit is factory-set to "1"
(Swedish).
• Step to the required language with the SUN or BUTTERFLY button.
• Press STOP to save.
• To exit programming mode, press STOP + BUTTERFLY (STOP button first). The display will restart and the new
language is set.
1
1
Stop button
2
Sun button
Extra drying
3
Butterfly button
Normal drying
Language symbol
0
1
2
3
4
5
6
7
Installation manual
Display language
English
Swedish
Norwegian
Danish
Finnish
Russian
French
German
2
3
fig.W01296
Advertisement
Table of Contents
