Connecting To An External Payment System; Restore Factory Settings - Electrolux DC6-8HP m Installation Manual

Drying cabinet

Table of Contents

7.3 Connecting to an external payment system

Connect the cables from the external payment system to terminal block positions 1 and 2 "EXT SW".

Activate the connection to the external payment system as follows:

• Activate the programming mode: Press STOP + SUN + BUTTERFLY. Press the Stop button first and then the pro-

gram selection buttons simultaneously. The display lights up and shows "ACCESS 1000". To be able to move on,

code 9191 must replace the code 1000.

• After the above, you will be at the first digit "1" in ACCESS 1000. Step to the digit "9" using the program selection

buttons SUN (up) or BUTTERFLY (down). Then move to the next digit, in this case "0", using the STOP button. In-

crease this to "1" using the SUN button and then continue until "9191" is shown. Once you have set the last digit,

press the STOP button and access programming mode.

• The first parameter and the factory-set value are then shown in the display. The row with the parameter flashes.

• Step forward or back with the SUN (increase) or BUTTERFLY (decrease) button to Parameter 117 is shown. Press

STOP to confirm.

• Set the parameter value to 1. This will activate the cabinet for network use. Use the Stop button to exit the

parameter.

• Press STOP to save.

• To exit programming mode, press STOP + BUTTERFLY (STOP button first).

Stop button

Sun button

Extra drying

Butterfly button

Normal drying

To restore the electronics to factory settings:

Press the Stop button, and then press both program buttons. The display shows FACT DEFS.

Installation manual

fig.W01529

fig.W01296

Table of Contents