Problem
Spots like rust appear
on catalytic enamelled
surfaces.
The oven interior
lighting switches off
after a short time.
The oven interior
lighting is off.
The oven interior
lighting does not switch
on.
Cause and remedy
The catalytic cleaning process does not remove
spices, sugar and similar deposits.
Take the catalytic enamelled panels out of the
oven and remove this type of deposit with a mild
solution of hot water and washing-up liquid
applied with a soft brush (see "Cleaning and care –
Cleaning the catalytic enamelled back panel ").
You have selected the
setting.
If you want the oven interior lighting to be
switched on during the entire cooking programme,
select the
Lighting
You have selected the
Press the sensor control to switch on the oven
interior lighting for 15 seconds.
If required, select the
setting.
seconds
The halogen lamp is faulty.
Risk of injury caused by hot surfaces.
The oven gets hot during operation. You could
burn yourself on the heating elements, oven
compartment or accessories.
Allow the heating elements, oven compartment
and the accessories to cool before manual
cleaning.
Disconnect the appliance from the mains. Switch
off at the wall and withdraw the plug from the
socket or switch off the fuse of the electrical
installation.
Turn the lamp cover a quarter turn anti-clockwise
to release it and then pull it together with its seal
downwards to take it out.
Replace the halogen lamp (Osram 66725 AM/A,
230 V, 25 W, G9).
Refit the lamp cover together with its seal and turn
clockwise to secure.
Reconnect the appliance to the electricity supply.
Problem solving guide
|
Lighting
"On" for 15 seconds
|
On
setting.
Lighting
|
Off
setting.
Lighting
|
On
or
"On" for 15
81