Table of Contents
Advertisement
To remove the insert: Push the insert
2.
upwards from below with your finger.
Clean the detergent dispenser tray
3.
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
4.
Fit the insert and lock it in place (push
the cylinder onto the guide pin).
5.
Push in the detergent drawer.
Cleaning and maintenance
Note:
Leave the detergent drawer open
so that any residual water can evaporate.
Drain pump is blocked
Note:
Turn the water tap off to prevent
more water from flowing in and to ensure
that it is drained via the pump.
:
Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down first.
Turn the programme selector to Off.
1.
Pull out the mains plug.
Open the service flap.
2.
3.
Take the drain hose out of the
retainer.
Remove the sealing cap and pour the
water out into a suitable container.
Replace the sealing cap and place the
drain hose back in the retainer.
en
41
Advertisement
Table of Contents
