Table of Contents
Advertisement
en
Positioning and connecting
Before washing for the first
time
The appliance was inspected thoroughly
before leaving the factory. To remove any
residual test water, run the Drum Clean
programme the first time without
laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
1.
Insert mains plug.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the Drum Clean 90°C
4.
programme.
5.
Open the detergent drawer.
Pour approx. 1 litre of water into
6.
dispenser II.
Add standard detergent to dispenser
7.
II according to manufacturer's
instructions for light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any woollens
or mild detergents.
Close the detergent drawer.
8.
9.
Select A Start/Pause .
When the programme ends, turn the
10.
programme selector to Off.
Your appliance is now ready for use.
20
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
2.
Reduce the water pressure in the
supply hose. ~ Page 42
3.
Drain any residual water. ~ Page 41
Disconnect the appliance from the
4.
mains.
5.
Remove the hoses.
Empty the dispensers.
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric
softener leaking from the
dispensers
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
1.
Remove the covers and keep them in
a safe place.
Note:
Use a screwdriver if necessary.
Advertisement
Table of Contents
