Operation (manual mode)
- If you touch the run-on control
again, the fan will remain switched on
( will go out).
Switching the fan off
Touching the control for the active
power level again switches the fan
off.
The deflector plate remains extended.
Run-on in Plug&Play operation
If you switch off the fan in Plug&Play
mode, it will run on at level 1.
Run-on ensures that the plinth is
ventilated after cooking.
Depending on the last active fan level,
run-on lasts between 2 and 30 minutes.
You can switch off the fan immediately
during run-on by pressing 1 or the On/
Off sensor .
This function is independent of the run-
on function .
28
Switching on and dimming the
cooktop lighting
The cooktop lighting can be switched
on and off and dimmed independently
of the fan.
With the deflector plate retracted,
touch the On/Off sensor .
All symbols light up with reduced
brightness.
Touch the lighting control briefly.
The deflector plate extends.
The lighting will switch on at maximum
brightness. All 3 bars next to the
lighting control light up.
To change the brightness, press and
hold the lighting control with the
lighting switched on. The brightness
will gradually dim until you release the
control.
To increase the brightness, press and
hold the lighting control again until
the desired level has been reached
and then release it.
Alternatively, you can select 3
brightness levels by touching the bars
next to the lighting control .
Switching the cooktop lighting
off
Touching the lighting control again
switches the cooktop lighting off.
The deflector plate remains extended.