LG SV-iC5 Series Instruction Manual page 77

Power On Start select
Group LED Display
Drive
drv
group
Function
H20
group 2
Set H20 to 1.
When AC input power is applied to the inverter with drv set to 1 or 2 {Run via control terminal} ON, motor
starts acceleration.
This parameter is inactive when the drv is set to 0 {Run via keypad}.
Particular attention must be directed to this function due to potential hazard as motor
starts to run suddenly upon applying AC input power.
Input voltage
Frequency
Run
command
Restart after fault reset
Group LED display
Drive
Drv
group
Function
H21
group 2
Set H21 to 1.
Motor starts acceleration if drv is set to 1 or 2 and the selected terminal is ON when a fault is cleared.
This function is inactive when the drv is set to 0 {Run via the Keypad}.
Particular attention must be directed to this function due to potential hazard as motor
starts to run suddenly after the fault is cleared.
Parameter Name
[Drive mode]
(Run/Stop mode)
[Power On Start select]
CAUTION
When H20 is 0
Parametern name
[Drive mode]
(Run/Stop mode)
[Restart after fault reset]
CAUTION
Set Min/Max
Value Range
1, 2
1
When H20 is 1
Set Min/Max
value range
1, 2
1
9-9
9. Basic functions
Factory
Defaults
0/3 1
0/1 0
Factory
defaults
0/3 1
0/1 0
SV-iC5
Unit
Unit