LG STB-3000 Setup Manual page 8

STB-3000 Cabling Connections (Cont.)
(Continued from previous page)
b) Use the HDMI cable provided to connect HDMI OUT on the STB-3000 rear jack panel to the HDMI1
input connector on the rear jack panel of the display. *
c) For RF delivered content, connect a 75 ohm coaxial wire from the Antenna/CATV wall jack to
ANTENNA/CABLE IN on the STB-3000 rear jack panel. For IP delivered content, connect an RJ-45
Ethernet (CAT5) cable from the institution's network to the LAN port on the STB-3000 rear jack panel.
d) Insert the DC power plug of the AC/DC power adapter provided into the POWER connector on the
rear jack panel of the STB-3000, and then plug the AC/DC adapter into a standard 120V 60 Hz AC
power outlet.
Once power is applied to the STB-3000, the LED on the STB's front jack panel will light steadily,
indicating that the STB is in standby mode. Also, the display panel will be turned OFF by the STB
as soon as the STB is powered and establishes Television/Display Control communication with the
display.
Note: Once Television/Display Control communication is established between the STB-3000 and
the display panel, the STB-3000 will be in control of the display panel, and certain resident panel
functions, like panel buttons, typically will no longer operate.
3. Use the Installer Remote to turn ON the STB/display panel.
While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at
a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks
off twice in rapid succession every five seconds. The first image you should see on the display panel is
a prompt to select the video output resolution (see "Setting the Video Output Resolution" on page 15).
4. Select the video output resolution (i.e., the STB's video output format), and complete the appropriate
Commercial Mode setup procedures, as described in this document.
Note: It is recommended that you complete STB-3000 Commercial Mode setup procedures before you
make external equipment connections to the STB-3000.
*
The STB default configuration automatically sends Television/Display Control commands to switch the connected
display panel to its HDMI1 input.
8
206-4272