After Use; Cleaning; Scales Cleaning - Panasonic NI-GWE080 Operating Instructions Manual

MORE USEFUL
To get better results, pull the garment
tight with one hand while
ironing with the other hand.
Ironing cloth can also be used to
support clothing to iron.
Notes:
a) T he maximum loading capacity of the hanger is 3 kg
while that of the hook is 2 kg.
b) Do not pull the clothing strongly during use, so as not to
roll over product.
c) Do not touch the steam, doing so may cause scalds.
d) When ironing with ironing cloth, do not place your hands
under the ironing cloth.
e) During the ironing process, water droplets will be
generated on the hanger part. It is normal for too much
water droplets to wet the clothes.
12

After use

1. Set the steam selector to " " position,
Set the power button to " 0 " position.
2. Place the steamer head into the steamer
holder on the hanger properly.
3. Turn off the power button, unplug the
power plug.
4. After 1 hour, take out the water tank
from the power base, open the cap,
shake the water tank to clean its inner
wall with the remaining water and then
drain the water tank.
5. Check that the lock button on the
telescopic pole is locked securely, lift
the whole product by holding both
telescopic poles with your hands, and
move the product to a safe place for
storage.
6. Store the product when the hose is straight.
Note:
With the telescopic pole being retracted,
the hose will become bent, and then will
interfere with movement of product.
Therefore, before retracting the telescopic
pole, please place and store the product
in a safe place as shown in the figure.

Cleaning

Cleaning and Maintenance of the steamer head and
power base and the hose.
Unplug the power plug, wait
1
until the steamer head, hanger
and power base have fully
cooled down.
2 Wipe the surface of the nozzle
and the power base with a soft
cloth. For stubborn stains, use
a soft cloth dipped with neutral
detergent to clean.
Pull upwards to remove the hose while rotating the
3
fixing nut, and clean the hose and the interface
between it and the power base.

Scales cleaning

To maintain optimal steam performance, it is important to
remove scales and impurities inside the appliance regularly.
It is recommended to perform the easy rinse calc-clean process
at least once a month.
Turn off the power button, and wait for about one hour
1
until the steamer head, hanger and power base have
fully cooled down.
Remove the telescopic pole, hose, and water tank from
2
the power base.
Pour the water in power base out from the hose hole (as
3
shown in the figure).
Place the power base on a horizontal
4
place, install the water tank containing
water on the power base, leave them for
about 10 seconds, and then
Hose hole
remove the water tank.
Pour the water in power base
5
out from the hose hole (as shown
in the figure).
13