Using The Garment Steamer; After Use - Panasonic NI-GSE050 Operating Instructions Manual

USING THE GARMENT STEAMER

1. Hang the garment on a hanger, and then attach the
hanger to the hook.
Insert the power plug into the household outlet.
2. Press the power button to light the power indicator up.
3. Wait about 1 minute when the product is ready to use.
And set the steam selector according to the required
" " / " " steam.
When gripping the steamer head, hold the handle.
Shaded area represents the hand-held area.
4. Steaming the clothes. We recommend to put the steam
head into the steamer holder when you sort out or change
your clothes.
5. Turn off the power when you have finished using, unplug
the power plug.
10
Note:
a) When the hose slacken, the steam will be clogs partially
with noise from hose.
b) If the amount of water in the water tank less than
" " line, please add water.
c) Do not remove the water tank and hose from the base
during use.
d) To close steam, turn off the power button.
e) There may be water dripping from nozzle on the
clothes, this is not a malfunction.
f ) Turn off the power button, unplug the power plug
when you take out the water tank from the power base.
FABRIC AND IRONING RECOMMENDATIONS
Fabric Steam selector
ACRYLIC, ACETATE
Level " ":
NYLON, SILK
For thin or delicate fabrics.
POLYESTER, RAYON
CHIFFON
Level " ":
WOOL
For thick materials, items with
COTTON, LINEN
stubborn wrinkles fabrics.
Note:
Do not use the appliance with leather fabric.
Test on an inconspicuous area when using with expensive
products, special materials, fibers weak against heat.
(Velvet, wool, cashmere, acrylic, silk, etc.)
MORE USEFUL
To get better results, pull the garment
tight with one hand while
ironing with the other hand.
Note:
a) Do not put over 2 kg on the hook.
b) Do not pull the clothing strongly during use, so as not to
rollover product.
c) Do not touch the steam, doing so may cause scalds.

AFTER USE

1. Drainage, Cleaning and Maintenance of the water tank
1 Turn off the power button, unplug the power plug.
2 After 1 hour, take out the water
tank from the power base, open 2
the cap, shake the water tank
to clean its inner wall with the
remaining water and then drain
the water tank.
2. Storage
1 Place the steamer head into the
1
steamer holder.
2 Set the steam selector
to the " " position.
3 Hold the telescopic pole to move
2
the product, and store the product
in a safe place.
4 Store the product when the
4
hose is straight.
Note:
With the telescopic pole being retracted, the
hose will become bent, and then will interfere
with movement of product. Therefore, before
retracting the telescopic pole, please place
and store the product in a safe place as shown
in the figure.
11