Panasonic WJ-HDE300 Conversion Manual page 9

WJ-HDE300 S-ATA conversion guide
(25) Secure the S-ATA cables to the cord clamps as shown below.
Leave the red circled areas empty to install the HDD mounting chassis.
(26) Adjust the length of S-ATA cables and secure them as shown below.
for HDD1
for HDD2
(27) Fix two HDD mounting chassis to the main unit with four
screws each from the top and two screws at front. There
are four holes on the front but use top right and bottom
left. Other two holes are used in step (34).
Take care not to pinch the S-ATA cables.
Panasonic System Solutions
Approx. 50mm
for HDD3
for HDD4
top right and
bottom left.
8
Maintenance guide
Approx. 80mm
Common to left and right
HDD mounting chassis
HDE300_SATAConversionGuide_B
S-ATA board