Panasonic WJ-HDE300 Conversion Manual page 7

WJ-HDE300 S-ATA conversion guide
(17) Remove five screws fixing the main board, and then fix
the main board with six hexagonal spacers (7 mm).
(18) Fix the S-ATA board mounting angle to the hexagonal
spacers with five additional screws.
(19) Fix one hexagonal spacer (22 mm) to the S-ATA board
mounting angle
.
(20) Insert two S-ATA boards into the ATA connectors on the
main board, and fix them with two screws each.
Note: Circled tapped holes on the S-ATA connector side are not
necessarily screwed.
(21) Attach eight cord clamps to the bottom of the main chassis
as shown right.
Panasonic System Solutions
Two screws that fixed the main board
Hexagonal spacers
(22mm)
SATA board
mounting angle
Hexagonal spacer
six screws (7mm)
6
Maintenance guide
210mm
70mm
100mm
HDE300_SATAConversionGuide_B
SATA
board
Without
screw
Additional
five screws
Main
board