Table of Contents
Advertisement
Chapter 5.
Maintaining the T17 Transducers
5.1
Removing Transducers
After the transducers are properly installed into the pipe nozzles as described in Chapter 4."Inserting T17 Transducers
into the Pipe", the T17 transducers require no additional adjustments. Periodic inspection of the installation to verify
the torque on the mounting bolts may be required, if erratic flow rate measurements are observed. If you suspect
something is wrong with a transducer or need to replace a transducer, use the removal procedure in this chapter.
5.2
Using the Insertion Mechanism
Use the steps below to remove transducers that have been installed with the insertion mechanism:
WARNING!
1. Disconnect the power from the flowmeter.
WARNING!
2. Disconnect the transducer cables at the junction box.
Model T17 Installation Guide
Follow all applicable safety codes while performing the following procedures.
Make sure the power is disconnected before performing the following steps.
Chapter 5. Maintaining the T17 Transducers
75
Advertisement
Table of Contents
