Figure 619 Mpt-Hlc Additional Settings Tab - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
Figure 619 MPT-HLC Additional Settings tab
55. Provision MPT-HLC radio link identifier:
56. Provision the MPT-HLC Synchronization Status Messaging
Note: If the MPT-HLC is part of a LAG, you cannot change the SSM or PPP settings on an
individual radio. Go to
ports.
822
i. Select Link Identifier Configuration Enabled check box.
ii. Enter the Expected Identifier value (0 to 255).
iii. Enter the Sent Identifier value (0 to 255).
iv. Click Apply.
Administer L1/L2 radio and L2 Ethernet LAG ports
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see
WebEML User Manual
to administer LAG
Figure 619.