Panasonic SF2B Series Instruction Manual page 36

<PNP output type (with SF2B-CB05-B)>
● I/O Circuit Diagram
Emitter
Internal circuit
Receiver
Internal circuit
● Wiring Diagram
Receiver Emitter
Notes: 1) The figure above shows the connection pattern for the SF1-CC□A. The pink cable is not used for the
NA40-CC□.
2) The figure above shows the connection pattern for the SF1-CC□A. The orange cable is used for the
NA40-CC□.
Make sure that the frequency selector at the insertion slot of
bottom cap cable on this device is set to "1" position for mas-
ter side sensor, "2" for slave side sensor (on both emitter and
receiver). If they are in the position other than the above, the
device may not operate properly.
36
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
Color code of SF1-CC□A (Optional)
(Brown) +V
(Pink) Test input (Note 1)
(Blue) 0V
(Orange / Purple) Interference prevention line
Users' circuit
(Brown) +V
(Black) Control output 1 (OSSD 1)
(Orange / Purple) Control output 2 (OSSD 2) (Note 2)
(Blue) 0V
Users' circuit
Color code of SF1CC□A (Optional)
(Brown) +V
(Pink) Test input (Note 1)
(Blue) 0V
(Orange / Purple) Interference prevention line
(Brown) +V
(Black) Control output 1 (OSSD 1)
(Orange / Purple) Control
output 2 (OSSD 2) (Note 2)
(Blue) 0V
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
*S1
Load
K1
* Switch S1
Open: Emission
+V or 0V: Emission halt
Symbol
K1: External device
Relay with forcibly guided con-
tracts or magnetic contactor
+
*S1
-
K1
Load
+
24V DC
±15%
-
24V DC
±15%
Frequency selector