Lubrication - Toro Workman 3000 Series Service Manual

Lubrication

Before servicing or making adjustments
to the machine, stop engine, set parking
brake and remove key from ignition
switch. Any load material must be re-
moved from bed or other attachment
before working under raised bed. Always
place the safety support on extended lift
cylinder to hold box up.
The differential drive shaft has 3 grease fittings that must
be lubricated regularly with No. 2 General Purpose Lithi-
um Base Grease. If the machine is operated under nor-
mal conditions, lubricate the shaft after every 100 hours
of operation. More frequent lubrication is required if
used for heavy duty vehicle operations (Fig. 78).
Front Wheel Drive Section – 4WD (Rev. F)
WARNING
IMPORTANT:When greasing the universal shaft
bearing crosses of the drive shaft, pump grease un-
til it comes out of all 4 cups at each cross.
1. Wipe grease fitting clean so foreign matter cannot
be forced into the bearing crosses.
2. Pump grease into the bearing crosses and slip
yoke.
3. Wipe off excess grease.
Page 10 – 38
Figure 78
Workman 4000 Series